duskdawn Posted April 14, 2017 Share Posted April 14, 2017 Hi, Must be easy enough, but how do you get the swing arm off a parajet v3? Gary Quote Link to comment Share on other sites More sharing options...
AndyB Posted April 14, 2017 Share Posted April 14, 2017 I had to change my frame when it got bent in the post! The inner end of the swing arm shaft is a slight tight fit in the housing. You will either need a slide hammer or...... a long bolt that fits the threaded hole, a socket bigger than the diameter of the shaft and a washer. Put the bolt through the washer and the socket, then screw into the thread. As you tighten it be careful to centre the socket so it clears the shaft and keep tightening to pull the shaft out. When you replace the shaft, be careful to get the rebated inner end of the shaft orientated so that it matches the machined step. I put locktight on it as well, since once the shaft has been removed it is not quite as tight as before! Quote Link to comment Share on other sites More sharing options...
duskdawn Posted April 14, 2017 Author Share Posted April 14, 2017 Andy, Thanks for that, will give it a go. I only need to knock it out and I'm not going to replace it. For ease I might just saw the thing off. Gary Quote Link to comment Share on other sites More sharing options...
Neilzy Posted April 14, 2017 Share Posted April 14, 2017 What you up to Gary I did send a pm Quote Link to comment Share on other sites More sharing options...
AndyB Posted April 14, 2017 Share Posted April 14, 2017 If you just want it apart, you can knock it through and it will push out of the way! Quote Link to comment Share on other sites More sharing options...
admin (Simon W) Posted April 14, 2017 Share Posted April 14, 2017 Dude don't saw it off!! lol As suggested, get a long bolt with the correct thread, screw it in a little (and I just use a flat edge and a hammer to tap it out) It should not be that hard to remove. SW Quote Link to comment Share on other sites More sharing options...
duskdawn Posted April 14, 2017 Author Share Posted April 14, 2017 Cheers guys. I'll have a re-think. My master plan was as below. Quote Link to comment Share on other sites More sharing options...
duskdawn Posted April 14, 2017 Author Share Posted April 14, 2017 Neilzy, Me up to?? Nothing... Wasn't me. I wasn't even there!! It was some other big kid that did it and ran away. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.