martinpa

A bit of PTFE tape on the thread seems to have done the trick, I also took the funnber seal out and turned it round.

Now I don't get petrol dripping in the car when I lay it down.

Thanks for the suggestions, i'll give it a go.

I wasn't sure if it was meant to have a seal or not.

Does anybody else have a seperate seal in the cap?

My top 80 fuel cap does not seem to seal properly, so when I lay it down to put it in the car it sometimes leaks and I get a small amount of petrol in the car.

Should it seal properly, I assume it should. If so should it have a rubber seal seal.

If I tighten it to tight the thread jumps, so i can't tighten it further.

Does anybody else have the same problem???

Any advice.

I did make a rubber seal, but the petrol seems not to like the rubber.

Name: Paul Martin

Motor: PAP top80

Wing: apco thrust hp / Nucleon WRC 27

Local area: Martlesham/Kesgrave, Ipswich

Anybody local please get in touch

Chaps,

I'm also looking for a location around the Martlesham area, where I can fly with permission.

If anybody knows of a site i'd appreciate any info