Event created by Kran
This event begins 29/03/18 and repeats every day until 31/03/18
FVPi will be holding an orientation fly-in at our Gunderman Airfield over the 2018 Easter long weekend. If you have nothing planned for the weekend or just want to get out of the house for the day, come on down. There's plenty of activities in and around the airfield to keep you, the wife and kids entertained such as fishing, swimming, bush walking or just kick back and relax along the river front if the weathers down.
Sunday breakfast will be supplied by the club, so bring essentials outside of the breakfast.
So, pack your motor,maybe a fishing rod or two and come down to enjoy the spectacular Hawkesbury.
Recommended Comments
There are no comments to display.
-
Posts
-
By Anthony Stark · Posted
Hello guys & girls, I’m looking into getting involved with Paramotoring, I’m based near Southampton and I would like some help on where to get training and wheee to start please. I thank you for your time and support kindest regards, Anthony -
By admin (Simon W) · Posted
I have asked Rob the Farmer / pilot to have a look SW -
Hi can now remember leaving it by the hedge ,could still be there as it was later on Sunday morning when I had my last flight,would love to get it back. Geoffw -
Hi just hope that someone has found a ozone wing bag at the Banbury pmc flyin . Just when for it and I quickly realised I had left it behind at the pmc meeting,anyone who found it .please let me know, Many thanks Geoffw.
-
By aviatorkev · Posted
After an engine out I cleaned the carb of a tiny amount of varnish like muck. Next flight was ok but the following one engine stopped again. I replaced carb gaskets, diaphragms, needle valve and internal filter also fuel lines and inline filter. Pop off was 19 and reset at 10psi. I pressurise the fuel tank by blowing a couple of times into the tank breather tube and prime by pressing button on carb but sometimes the fuel has just reached the carb as normal BUT not filled the carb! I can remove the Diaphragm cover and diaphragm, press the metering lever to open the needle valve and no air or fuel comes out! When I disconnect the fuel pipe to the carb and reconnect it, then priming occurs as normal. Any suggestions as to possible causes or solutions would be very welcome thank you.
-
