Jump to content

Polini Throttle Cruise Control


custom-vince

Recommended Posts

http://www.flickr.com/photos/88705555@N00/8050832976

There is a few photos showing before after and internals of Thor throttle.

4mm bolt, 4mm drill, 4mm thumb screw. What you can see are the 3 plastic shims I added inside. About 20mm with 10mm hole approximately. I hand cut them from food packing plastic. I also added a rubber grommet to the thumb screw so it hold tight even when loosened off.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Upcoming Events

    No upcoming events found
×
×
  • Create New...