pintail120

Hi

I just purchased a Nucleon WRC27. I normally connect up my speed bar in flight. I am able to connect the speed bar clips in and there is no excess play in line length to speed bar, however when I push the speed bar out the two pulleys still have an inch gap between them - are my legs just too short ?

Any great ideas to over come this?

Thanks

Gavin

Remember by replacing the missing bit on the end with a lump of resin the CG will now be out even tho you balance it again.

Both props should balance at the same point on each blade(that's if the prop comes apart)

Cheers

Gav

Hi

I have installed the ROS 125 exhaust and both springs have broken off after 5 hours flight. Any ideas to save springs?

Thanks

Gavin

Hiya,

Could somebody please tell me whats the nearest city to look at on XCweather to get an accurate forecast?

thank you kindly

Gavin

Fuel vaporisation occurs in the fuel line when you have things like fuel filters in line. I have a single Walbro fuel filter/clunk at bottom of tank. The pipe that exits tank goes directly to the carb, no filters inline or pumps. If you add weight to the fuel pipe by adding a fuel filter its an agitator when vibrating (caused by engine vibration) this then assists fuel vaporisation in the pipe and appears as tiny bubbles. You then pull out lots of hair trying to work out where leak is and there is no leak. I have attached a picture but not sure if that is clear enough.

Make one of these to isolate your RF radiation from your cockpit area

http://xplorer.co.za/wonder-whip/