Jump to content

Icom 40S TX/RX Cloning Problem


Recommended Posts

Hi, I have an Icom 40S that needs a few more channels programmed into it. I have Windows 7 32 bit installed and no RS 232 ports fitted only Usb ports, I also have DosBox installed as the program EX2118 #2 requires Dos to run. Here is my problem, I get ( Err: Cannot access RS232c port) I have tried various drivers and emulators to connect with the radio via Icoms genuine OPC-478UC (I used this as I have a Icom 41W,worth a shot!)cabling and associated drivers even though the correct cable is the OPC-478 which is a RS232 serial cable. Your help would be appreciated.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share



  • Upcoming Events

    No upcoming events found
×
×
  • Create New...