tonyp Posted May 1, 2010 Share Posted May 1, 2010 Hello all, I have recently purchased a rad MXL with the standard high hang point rad harness. The problem is it has never been flown and therefore the harness is not fitted correctly and is very loose, when on my back it moves/distorts badly under power, can anyone advise how and where the bottom connector straps should go from harness to motor ??? Tried RAD themselves but the picture supplied was of no help.............any advise would be greatly appreciated !!!!.... Cheers, Tony. Quote Link to comment Share on other sites More sharing options...
garyfreefly Posted May 1, 2010 Share Posted May 1, 2010 give it to Pete......he will sort it....if not try ..... Jimmy Bypass .....!! (its in code if anyone else is wondering) Quote Link to comment Share on other sites More sharing options...
tonyp Posted May 1, 2010 Author Share Posted May 1, 2010 If all else fails I could swap it for your motor........... Quote Link to comment Share on other sites More sharing options...
mark_t Posted May 3, 2010 Share Posted May 3, 2010 Hi Tonyp This is me setting up my rad The angle is set up wright for me at that angle but I did pull the shoulder straps in so they were closer to me , the top and bottom fastenings have about 1 inch of slack in them . If you stand still and put full throttle on full it dose twist with the torque Hope this helps i have put new image in my gallery Quote Link to comment Share on other sites More sharing options...
Guest Posted May 4, 2010 Share Posted May 4, 2010 Pics are here.. gallery2.php?g2_itemId=2155 To see peoples pics, go to there profile and look at the bottom of the page where they are displayed. SW Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.